2 x Isovalve IsoAppTapSw2015 (“piggy-backed”)

Features:

  • Removable and interchangeable outlet nipples (10, 15 and 20mm outlet nipples available) allowing any configuration
  • Needle valve for excellent flow control
  • Inline filter
  • Conventional tap handle
  • 20mm and 15mm IsoNipples
  • Hot and Cold Indicators
  • Retainer on 20mm cap
  • Precision Machined DZR brass; chrome plated

IsoAppTapSw2015 x 2 “Piggy-backed”

Use
The Isovalve IsoAppTap swivel range has been designed to be used as a service and flow reduction valve to be installed prior to a plumbing fixture or appliance.
“Piggy-backing” the IsoAppTapSw2015 onto a dual outlet gives you the ability to effortlessly connect three fixtures without ugly brass tees.
Utilise the interchangeable outlet nipples to match the fixture.

Features and Benefits
Removable and interchangeable outlet nipples (any configuration using 10mm, 15mm and 20mm outlet nipples) allow flexibility while the inline filter means tapware complies with warranty conditions.
The needle valve allows for excellent flow control.
Swivel nut connection with seal.
Very quick connection to machined surfaces.
No need to apply sealant in confined spaces.
The IsoFlange (IsoWFF) slides over the linear shape of IsoAppTap reducing the need to be accurate with nippling tube.

Build of Materials
Brass – DZR Brass 352 precision machined bar
O-Rings– twin Nitrile O-Rings Durometer Hardness Duro 70
Washer – Acetyl
Surface Finish – Chrome Plating
Filter – Nylon PA-66 & 304 Stainless Steel 40×40 Mesh Aperture 0.42mm

Flow and Pressure Operation
Operating Pressure – Min 20kpa to Max 1600kpa
Maximum Test Pressure – For pipework pressure testing up to 2000kpa
Minimum Pressure – At the minimum operating pressure of 20kpa a single Isovalve will deliver a maximum 6.5L/min.  When installed prior to a typical ceramic disc faucet (which will deliver approximately 4.25L/min @ 20kpa) the Isovalve will have no significant effect on the flow of water from the faucet.
Typical Operating Pressure – At a typical operating pressure of 750kpa  (a single Isovalve can deliver a maximum of approximately 33L/min.)

Operating Temperature Range
Short term – Min 0’C to Max 90’C.  Extended term 60’C.

Certification and Standards
Isovalves and accessories are manufactured and certified to comply with ATS5200.012, AS3688:2005 and ISO5208
DZR Brass complies with AS2345
WaterMark Certification pending.

Guarantee
Every Isovalve is factory tested before packaging.  Isovalves are guaranteed against defective parts for a period of five (5) years.

What the plumbers say