IsoValve Female Duo Outlet (IsoDuo)

Supplied with:

  • IsoFilter
  • IsoDome handle
  • 15mm Isonipple
  • Plastic sleeve
  • 4mm allen key
  • IsoPlug
  • Tamper-proof cap
Master Assembly Details - Isovalve Female Dual Outlet

Master Assembly Details – Isovalve Female Dual Outlet

Isovalve Female Duo

The Isovalve Female Duo (IsoDuo) is ideal for situations requiring additional water supply (e.g. sink and dishwasher).  Simply remove the IsoPlug and fit the required nipple – 15mm, 10mm or 20mm.

Benefits of Isovalve during Fixture installation:

    • No need to turn off the water
    • No need to remove test plug
    • No water spills or flooding through joinery or flooring
    • No need to install brass nipple and standard isolating valve
    • Fixtures can be commissioned before moving on to next appliance
    • No need to drain down plumbing system
    • Several times faster installation than traditional method

Use
The Isovalve Duo is designed to be used as a service and flow reduction valve which are installed prior to a plumbing fixture or appliance.

Build of Materials
Brass – DZR Brass 352 precision machined bar
O-Rings– twin Nitrile O-Rings Durometer Hardness Duro 70
Washer – Acetyl
Surface Finish – Chrome Plating
Filter – Nylon PA-66 & 304 Stainless Steel 40×40 Mesh Aperture 0.42mm

Flow and Pressure Operation
Operating Pressure – Min 20kpa to Max 1600kpa
Maximum Test Pressure – For pipework pressure testing up to 2000kpa
Minimum Pressure – At the minimum operating pressure of 20kpa a single Isovalve will deliver a maximum 6.5L/min.  When installed prior to a typical ceramic disc faucet (which will deliver approximately 4.25L/min @ 20kpa) the Isovalve will have no significant effect on the flow of water from the faucet.
Typical Operating Pressure – At a typical operating pressure of 750kpa  (a single Isovalve can deliver a maximum of approximately 33L/min.)

Operating Temperature Range
Short term – Min 0’C to Max 90’C.  Extended term 60’C.

Certification and Standards
Isovalves and accessories are manufactured and certified to comply with ATS5200.012, AS3688:2005 and ISO5208
DZR Brass complies with AS2345
Australian WaterMark Certification Licence No. WTS-012

Guarantee
Every Isovalve is factory tested before packaging.  Isovalves are guaranteed against defective parts for a period of five (5) years.

Link to Technical Specs: https://www.isovalve.co.nz/wp-content/uploads/2018/05/Technical-Specifications.pdf

What the plumbers say

“Saves a lot of leakage”

VinceWayne Sizemore Plumbers, Dunedin